HV Control
HV Control
The High Voltage Control object controls, monitors, and displays all HV parameters for the NCD experiment. This is an object specific to the NCD experiment and works only in conjunction with the Mux controller.
Enter the values of the HV supply slope and offset to have the read back values correctly match actual values.
HV relay control for HV supplies tat are enabled (only possible when HV is at zero Volts.
Ramp controls for HV supplies that are enabled
Check which supplies to control, enter the ramp up time and the desired voltage. Displays the voltage currently being written (DAC), actual current (nAmps), and state of supply (On, Off, Ramping Up, Ramping Down, Panic)
Set interval between HV parameter checks and display of values
Full Panic of all HV (enabled when at least one supply is on)
Set location where HV parameters stored
Optionally save the currents to file
Strip chart of the HV currents over time.