SIS 3300/3301
SIS 3300/3301
Read out an event and show the waveform. Disabled during runs
MHz (for an individual channel) and a resolution of 12/14-bit. The board is a single width
6U VME card and has no special (i.e. non standard VME) voltage requirements.
Dual memory bank functionality in conjunction with multi event memory structure and a
range of trigger options give the unit the flexibility to cover a variety of applications. This board is compatible with the VME64x standard. In ORCA it can be placed into either a standard VME crate or the VME64 crate.
ORCA transparently supports both the 3300 and 3301 versions of the card.
The card is too complex to provide full details here. See the manual for more specific information.
Control Status Register Bits. The Enable Internal Trigger Routing should normally be selected as a minimum
Set the VME Address
Acquisition control register bits. For single event mode you would not select anything here. But you should select Auto Wrap.
Write and read back a pattern to the memory bank
Helpful Hint.
Use Cmd-Shift-> and Cmd-Shift-< to make this dialog control a card in the slot to the right or left of the currently selected card.
Use Cmd-C to bring up another card dialog, set one of them to the Rates display and one to the Settings display to see rates while setting thresholds.
Trigger thresholds - in raw adc units.
Rate over time.
Channel-by-channel rates. Note that you can enable/disable channels here also
Waveform record:
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
^^^^ ^^^^ ^^^^ ^^----------------------- Data ID (from header)
-----------------^^ ^^^^ ^^^^ ^^^^ ^^^^- length
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
--------^-^^^--------------------------- Crate number
-------------^-^^^^--------------------- Card number
--------------------------------------^- 1==SIS33001, 0==SIS3000
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx-Trigger Event Word
^---------------------------------------1 if ADC0 in this event
-^--------------------------------------1 if ADC1 in this event
--^-------------------------------------1 if ADC2 in this event
---^------------------------------------1 if ADC3 in this event
-----^----------------------------------1 if ADC4 in this event
------^---------------------------------1 if ADC5 in this event
-------^--------------------------------1 if ADC6 in this event
--------^-------------------------------1 if ADC7 in this event
------------^---------------------------1 if wrapped
---------------^^^^ ^^^^ ^^^^ ^^^^ ^^^^-Event Data End Address
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
^^^^ ^^^^-------------------------------Event #
----------^^^^ ^^^^ ^^^^ ^^^^ ^^^^ ^^^^-Time from previous event always zero unless in multievent mode
waveform follows:
Each word may have data for two ADC channels. The high order 16
bits are for ADC0,2,4,6. The low order bits are for ADC1,3,5,7
if SIS3300:
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
^----------------------------------------Status of User Bit
--------------------^--------------------Status of Gate Chaining Bit
---^-------------------^-----------------Out of Range Bit
-----^^^^ ^^^^ ^^^^------^^^^ ^^^^ ^^^^--12 bit Data
if SIS3301:
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
^---------------------------------------Status of User Bit
--------------------^-------------------Status of Gate Chaining Bit
-^-------------------^------------------Out of Range Bit
--^^ ^^^^ ^^^^ ^^^^---^^ ^^^^ ^^^^ ^^^^-14-bit Data
The largest page size (128K) is not currently supported.
Write all parameters to HW. Normally this is done automatically at the start of run